how to wire a double light switch

Do-it-yourselfers may be intimidated by the task of wiring a double light switch, but it’s actually quite simple. All you need is a bit of confidence and the right instructions. With just a few steps and some basic safety equipment, you can easily wire a double light switch.

First, you’ll need to turn off the power to the switch. You can do this by turning off the circuit breaker that controls it in the main electrical panel. Once the power is off, you’ll want to remove the cover plate from the existing switch. You can then disconnect the wires from the old switch and attach them to the new double switch. The black wire should be connected to the lower terminal of the incoming supply, and the white wire should be connected to the upper terminal.

Next, you’ll need to connect the two outgoing wires from the double switch. These will typically be two black wires. Attach each wire to either side of the switch. Finally, you’ll want to connect the ground wire to the green screw on the back of the switch. Once your wires are secured, you’re ready to put the cover plate back on and restore power. Double check all connections to make sure they’re secure. After testing the switch, your double light switch is now wired correctly.

By following these steps, you can easily wire a double light switch. Just remember to always take safety precautions when working with electricity and consult an expert if you’re unsure. With the right supplies and a little bit of confidence, you can have your double switch up and running in no time.

Changing And Old Two Switch Light Diynot Forums