how to wire diversitech 120-volt thermoplastic condensate pump lcv-120

If you are looking to install a Diversitech 120 Volt Thermoplastic Condensate Pump LCV, it is essential to know how to safely wire it. To ensure that the pump is properly wired and working correctly, here are some steps to take when wiring the device. First, it is important to ensure that the power source for the pump is turned off. This will make sure that the wiring is done safely and that the device does not receive power until it is ready to be used. After the power has been shut off, next is to properly attach the power wires to the motor terminals. This can be done by attaching the black wire to the L1 terminal and the white wire to the L2 terminal. At this point, the ground wire should also be attached to a grounding point on the motor base. Finally, the power cord should be plugged into a GFCI outlet. This will ensure that the device is protected from any potential power surges. Once all the wiring is connected and the power is on, the pump can be tested to make sure it is working properly. It is essential to follow these steps carefully to ensure the pump is wired correctly and that it functions optimally. By following these steps, you can easily wire your Diversitech 120 Volt Thermoplastic Condensate Pump LCV and have it up and running in no time. Not only will it help ensure that your device is safely and properly wired, but it will also help it run more efficiently and for longer periods of time.

Diversitech Cp 22t Condensate Pump 120 V 4 Inlet Holes 22 Of Lift Com